Cart is empty
0

My Cart

item(s) - USD0.00

Review Details

Alunar M605 DIY 3D Printer

Alunar M605 DIY 3D Printer

Product Review (submitted on August 10, 2017):
i assembled and started to use this printer and after printing a few small items all was going well. after the unit sat around for a few weeks, i tried using it but the display wasn't being initialized correctly...just all blank characters. i reached out to customer@aluna.net but never got a reply back from them. since i'm an electrical engineer, i did some debugging of the problem and found out the 16Mhz crystal went bad so i replaced that and the printer is back working. i hope to get many months of use out of the unit now a will be glad that i purchased if it doesn't break again in the near term